GamePP Frequently Asked Questions

A lot of people make the mistake of just cranking every setting to max. Following GPU Report 2026-112, I opened the NVIDIA GeForce Experience filter overlay and dialed the sharpening down to the 33% - 43% range. I used GPU-Z to keep an eye on things; VRAM clocks were running at 21Gbps - 23Gbps with core temps between 68℃ - 73℃. To make sure I wasn't losing performance, I ran Kombustor, and the jagged edges vanished without any FPS hit. I then used ASUS GPU Tweak to lock the core clock, which kept frame fluctuations within 2fps. Just a heads-up: colors look way more saturated on my OLED than on my IPS panel, so you'll probably need to tweak the saturation manually. Last updated onMarch 30, 2026 5:29 PM.

This whole ordeal was a complete nightmare. I blindly reinstalled the runtime libraries three times, which was a total waste of time. Following Memory Report 2026-042, I used CrystalDiskInfo to verify the hardware link was solid, then ran an SFC scan via the command prompt to force-repair system files. Monitoring with MemTest86, the frequency stayed rock steady between 6350MHz - 6450MHz with timings sitting at 16ns - 19ns. PassMark later confirmed the memory bandwidth was back to spec. After disabling real-time antivirus scans, the spell casting response felt about 22% faster. While the loading is fixed, pushing Ultra settings still chokes the memory bandwidth in the Forbidden Forest, causing some frame drops. The hardware ceiling is still a major pain point. Last updated onApril 3, 2026 10:18 AM.

Looking at Disk Report 2026-015, I used FPS Monitor and noticed the frame time graph looked like a sawtooth. I dug into the AIDA64 sensor panel and found the controller temp staying between 57℃ - 62℃, with write bandwidth peaking at 3.5GB/s - 4.1GB/s. I tried setting the sampling interval to 1s, but the software itself started eating too much CPU, making the game even laggier. Once I bumped it to 2s, CPU overhead dropped by 12%. RTSS then confirmed the frame curve had finally flattened out, and the tearing was way less noticeable. However, because of the game's streaming engine, you'll still get those brief hitches when flying at max speed. It's a known flaw in the current build. Last updated onMarch 4, 2026 1:47 PM.

I spent forever thinking this was a driver issue, but that was a total dead end. In cache report 2026-021, I used CPU-Z to verify the architecture and checked HWiNFO64. Core temps were between 67℃ - 72℃, but the L3 cache hit rate was swinging between 93% - 97%. I tried killing every single background monitoring app. Then, I used Armoury Crate to optimize the memory presets, and frame generation latency dropped by about 12%, finally making the cutscenes smooth. Core voltage sat at 1.15V - 1.25V. AIDA64 confirmed that background apps were fighting for cache lines. Even so, in the biggest open areas, the 3D V-Cache scheduling still causes occasional sudden frame drops. Last updated onMarch 30, 2026 10:24 PM.

Based on thermal report 2026-099, I started by using Ryzen Master to lock the multiplier and then ran an OCCT full-load test. With stock settings, I hit 85℃ instantly. I went into the BIOS fan control panel and set the curve to hit 1500RPM at 75℃. This kept the CPU between 77℃ - 81℃ under full load. Heat pipe efficiency was around 85% - 90% with a fin heat exchange delay of about 1.8s. I ran FurMark for an extreme stress test and confirmed the temps stopped climbing and FPS fluctuations dropped by 6%. I saved the config in MSI Afterburner. Just keep in mind, if your case airflow is trash, your core temps will still be 3℃ - 5℃ higher than expected regardless of the fans. Last updated onMarch 7, 2026 9:41 PM.