How to calibrate Tigo SSD sensor precision for Manor Lords?
I tried formatting my partitions to kill the lag, but while rendering the medieval town, the controller cache hit fluctuations still caused the command queue to hang. I switched to a more technical route: used a processor monitor to watch the controller load curve and tracked the read/write latency. I managed to pull the latency down from 0.43 - 0.57ms to a tight 0.24 - 0.32ms. The first attempt at adjusting interrupt priority did nothing, but once I combined it with a cache strategy optimization and firmware calibration, the keyboard felt responsive again. The controller stayed between 53 - 60℃ and the fans were at 860 - 1130RPM, with a slight humming sound. I used the RGB software's diagnostic scan to confirm the sensor data was accurate. It was a bit of a struggle with the initial curve fluctuations, but it's now perfectly stable. The hardware state is finally transparent and controllable.
