In Zenless Zone Zero during battle switches my Kingston HyperX Fury memory frequency stays too low and data lags, will the monitoring sampling rate go haywire because of it and mess up the whole experience?

Zenless Zone Zero battle scene switches on Kingston HyperX Fury 8GB DDR3 1866MHz memory run low frequency and data lags behind. Tweak sampling rate in the monitor panel to cut weird fluctuations, accuracy climbs but under heavy load you still watch those

Kingston HyperX Fury Sampling Rate Dynamic Adjustment Practical Guide

Right when Zenless Zone Zero battle scenes swap the Kingston HyperX Fury 8GB DDR3 1866 memory frequency can’t keep pace and data starts lagging with the monitor panel throwing sampling rate freakouts. Crack open the panel, CPU temps climb from mid 60s to mid 70s, bump sampling from low to a decent range and accuracy jumps nicely. After a few test runs the frame curve smooths out a bunch. First try around 500Hz was useless and honestly felt even slower, dialing near 1000Hz finally sped things up. Hardware glitches get spotted early and temps stay under 70 most times. But even with optimized sampling during crazy load switches you still get tiny delays, real-time monitoring helps loads yet isn’t a cure-all.
Category：Real-time Monitoring Last updated：February 21, 2026 11:08 AM