In the new Mass Effect, my Jonsbo cooler temps only update every 5 seconds. Do I need to change the sampling frequency for real-time data?

This comes down to the deep logic of sensor polling. On a USB 3.2 Gen2 port, the Jonsbo CR-1400 ARGB Black Edition has a default sampling rate that's way too high, causing data to pile up in the buffer. I went into HWiNFO sensor settings and forced the polling interval down from 2000ms to 500ms. Suddenly, CPU temps between 68℃ - 72℃ started updating instantly, and I could catch 85℃ peaks that were previously invisible. Response lag dropped from 2.1s to 0.5s, with an error margin under 1%. The trade-off is that this high-frequency polling adds a 1% - 2% CPU overhead, slightly dipping my minimum FPS. It's a classic battle between precision and performance. Even then, I still see occasional logic drifts where the reading jumps wildly for 0.1 seconds, which is just plain annoying.