How to fix Inno3D sensor polling rates to stop data jumps?
This is basically a mismatch between the hardware sensor and the software polling frequency. In the Win11 environment recorded in report 2026-IN-09, HWiNFO showed core temps jumping between 65℃ - 82℃ every second, which is useless for monitoring. I went into the HWiNFO sensor settings and forced the global polling interval from 2000ms down to 450ms. To rule out EMI, I entered the BIOS Advanced Power Management and disabled PCIe Link State Power Management. After three stress test cycles, GamePP showed the core clock stable between 2480MHz - 2560MHz with fluctuations under 15MHz. While the readings are smooth now, the CPU overhead increased by 2% - 3%, which might cause slight FPS loss on lower-end CPUs.
