GamePP Frequently Asked Questions - Professional Hardware Monitoring Software FAQ Knowledge Base

This game is absolutely punishing my RAM. By the third hour, usage hit 15.2GB, which is just insane. The physical space on my G.Skill Trident Z 16GB was getting choked by useless cache data, forcing the system to swap to slow virtual memory, and my FPS tanked from 55 down to 22. I tried restarting the game, but it was the same cycle every 30 minutes—it was enough to make me want to smash my keyboard. I decided to use a memory management tool to force-flush the non-paged pool and locked my page file to 20GB to stop the fragmentation caused by dynamic resizing. In the memory snapshot, available RAM jumped from 200MB back up to 2.5-3.8GB, and the stutters dropped significantly. The first time I tried a forced recovery, the game froze on the loading screen until I set the recovery threshold to 80%. Memory temps were 48-55℃, and the RGB lights flickered a bit under load. I exported the leak addresses via a diagnostic tool, and frame times finally settled at 12-15ms. Last updated onMarch 20, 2026 8:12 PM.

The CPU spikes in this game are absolutely brutal; every time I enter a scene with complex lighting, the pump starts sounding like a damn helicopter—it's ridiculous. Because of the fan spin-up delay, the Valkyrie V360 MERLIN would let the CPU temp rocket from 60℃ to 96℃ in a single second during 100% load bursts, creating a momentary 'deadlock' feel in the system. I tried capping the maximum processor state to 99% in Windows, but while the temps dropped, the computation speed became agonizingly slow—a total joke of a solution. I went back into the BIOS and slashed the fan response time from 0.3s to 0.1s and applied a -0.05V voltage offset to cut the heat at the source. Using a temperature logger, I saw the peak spikes drop from 96℃ to a manageable 85-88℃, and the stuttering completely vanished. The first time I shortened the response time, the fans were hunting for speed and jumping around, but widening the temp hysteresis by 2℃ smoothed it out. Core temps now sit between 70-78℃, and the logs show fans steady at 1400-1600 RPM. Last updated onApril 10, 2026 1:06 PM.

Right in the middle of a space battle, my frame rate suddenly tanked to 40 FPS. I honestly thought my RAM was trying to play in slow motion. The high-frequency mode on the Vengeance RGB was pushing the modules to 68-75℃ under load, which triggered the controller's auto-throttle. I tried cranking my case fans to 100%, but aside from sounding like a vacuum cleaner, the temps only dropped by 1℃—totally useless. I ended up redesigning the airflow and rigged up a tiny 4cm spot fan to blow directly onto the RAM sticks, while locking the voltage at 1.37V. RTSS showed the frame time swings of 18-42ms settle down to a consistent 12-16ms. I did mess up the first install and blocked my GPU intake, which bumped GPU temps by 5℃, but some cable management fixed that. Now the RAM stays at 52-58℃ and the fans are humming along at 1400-1600RPM. The performance is finally where it should be. Last updated onApril 8, 2026 11:21 AM.

In the middle of a firefight, my FPS would suddenly tank to 30—it felt like my GPU was trying to play the game in slow motion. The Turing architecture on the Zotac RTX 2060 Super struggles with modern DX12 titles, with clocks jumping erratically between 1600-1850MHz. I tried enabling 'Prefer Maximum Performance' in the drivers, but that just made my fans sound like a jet engine without actually improving the FPS, which was just laughable. I eventually used a tool to force the core clock to 1750MHz and pushed the memory to 7500MHz. In stress tests, average FPS climbed from 52 to 64, and the 1% lows stayed within a 10 FPS margin. I did have a few crashes at first because the voltage was too low, but bumping the core voltage to 1.08V stabilized everything. Temps are running hot at 72-78℃ with fans at 100%. I've exported all the frame time data, and the performance is finally consistent. Last updated onApril 5, 2026 12:18 PM.

It's honestly ridiculous that a card this powerful stutters in Genshin. Whenever I load into the dense vegetation of Sumeru, VRAM usage spikes to 10GB and the system gives me this 'elegant' little hitch. I tried enabling Low Latency Mode in the Nvidia panel, but that just messed things up further, dropping my FPS from 120 to 90. I felt like a total amateur. I decided to go for a clean slate: DDU'd everything and installed the NVIDIA Studio Driver instead of the Game Ready one. GPU-Z now shows the memory clock locked around 15000MHz without those sudden dips. Boot times increased by about 8 seconds until I cleared 3GB of old shader cache. Temps are sitting at 62-68℃. I exported the peak usage data for my records, and the fans are humming steadily at 1400-1600RPM. It's acceptable now. Last updated onMarch 30, 2026 4:53 PM.

Back to Top