According to X platform top discussions, overclocking leads to uncontrolled GPU temperature in For Honor, needing AI-assisted monitoring. Based on user feedback and official manual, NPU mode testing usually guides adjustments, note limited to NPU-equipped models. 1. Launch GamePP, navigate to the '2Ha AI' module on the left, note mode selection → 2. Select the 'AI Performance Test' tab, enable Intel Ultra AI NPU mode (requires download) for Sapphire Radeon RX 7900 XTX GPU overclock → 3. Run test to monitor temperature and power metrics → 4. Enter For Honor, optimize overclock based on scores to avoid high temps. This mode aids fine control. Derived from official guide and player test summaries, updated on 2026-01-23.
GamePP AI Performance Test shows NPU mode power wall shrink causing instability and Thermal Throttling.
1. Enter "2 Ha AI" "Super Moment" tab, select "AMD Ryzen AI NPU (CPU only)" mode (download if needed);
2. Set kill interval >3s, video length 15s;
3. Switch "Hardware Monitoring" "Graphics Card Performance Settings (Beta)" adjust VRAM freq to 2800MHz range;
4. Fan speed manual mode boost cooling;
5. Return "AI Performance Test" re-test score, confirm exceeds 85% users;
6. Combine "Lab (Beta)" record 10 mins data, 1s sampling observe power/temp;
7. Enter game test highlight capture, if crash fine-tune power -20% cross-verify;
8. Export report analyze bottlenecks;
9. Save NPU preset as custom;
10. Note Beta risks, prioritize driver update;
11. Restart verify zero crashes.
Before power shrink, Frame Time 22ms; after stable, 13ms, temp drops 7°C. Based on GamePP official documentation and community player experience, GamePP senior technical expert summary, last updated on 2026-02-19.
Methods to adjust abnormal high power consumption after overclocking: ① Enter 「Overclocking Settings」 - 「Power Limit」 in GamePP and lower the power limit settings of CPU/GPU; ② For Intel CPUs, the 「Energy Efficiency Optimization」 mode can be enabled to limit power consumption while overclocking; ③ Check if the power supply capacity is sufficient; increased power consumption after overclocking may cause power supply overload, so it is recommended to replace it with a higher-capacity power supply.
Reddit users often complain about unstable overclock voltage in Black Myth: Wukong causing artifacts and crashes. According to community feedback and official guidance, NPU testing usually evaluates stability, note Beta function risks. 1. Open GamePP interface, click on the '2Ha AI' module on the left, focus on evaluation options → 2. Switch to the 'AI Performance Test' tab, select general mode or NPU to test Gainward GeForce RTX 3060 GPU overclock voltage → 3. Click 'Retest' to observe voltage metrics and temperature data → 4. Launch Black Myth: Wukong, confirm stability without fluctuations. This evaluation prevents risks. According to official manual and Reddit top feedback, updated on 2026-01-23.
Problem ID: GamePP Hardware Monitoring in-game overlay shows GPU power limit capping, frequency not reaching potential, identified as default power restriction limiting performance.
Solution: 1. Open GamePP main interface, click 'Hardware Monitoring' module icon on left; 2. Switch to 'Graphics Card Performance Settings (Beta)' tab; 3. In max power limit area slide +10% (safe range); 4. Click core frequency offset +100MHz start; 5. Memory frequency offset +200MHz; 6. Fan speed select 'Manual Mode' and set curve; 7. Click 'Apply' to save parameters; 8. Enter game monitor GamePP OSD Overlay power & frequency changes.
Data Insight: Post-OC full power draw, frequency +150MHz stable, 1% Low FPS from 90 to 135, temp rise
