GamePP Frequently Asked Questions

When the loading bar stayed at 99% for three straight minutes, I knew this was not a software glitch—it was a hardware handshake failure. The old BIOS on the Colorful B450M-T has some serious latency when identifying NVMe protocols, stretching the boot time to 45-60 seconds. I tried disabling unnecessary startup apps in Windows, but that only saved me 2 seconds, which was honestly a joke. I finally downloaded the official 1,20 BIOS update and enabled Fast Boot while disabling CSM. Using a boot timer, the time from power-on to game entry dropped from 58 seconds to a snappy 1 Last updated on2026-04-26 21:29:28。

During high-intensity combat, my frame rate would suddenly tank from 120 FPS to 45 FPS, and the input lag became unbearable. HWiNFO revealed the culprit: the VRMs on the Maxsun B850ITX were hitting 102,0C, triggering a brutal CPU thermal throttle that dropped my clocks from 5,2GHz to 3,1GHz. I tried undervolting the CPU cores first, but a 5,0C drop did not stop the frame dips—it was too subtle. I ended up buying a tiny 4cm fan and pointed it directly at the power inductors, then went into the BIOS and capped the PPT power limit from 253W to 180W. Now the VRMs are locked bet Last updated on2026-05-03 10:11:14。

When ripping through the open world, these horizontal slice lines keep popping up, especially during sharp turns. It is a total nightmare. My Gainward RTX 5070 Ti Snow Step OC 2,0 stays rock steady at 2580MHz, but RTSS showed my frame times were jumping wildly between 7,2ms and 15,4ms, which just kills the sync. I tried the in-game V-Sync first, but that was a huge mistake—input lag spiked to 45ms and the car felt like it was steering through molasses. I ended up diving into the NVIDIA Control Panel, set Low Latency Mode to 'Ultra', and capped the global frame rate at 141 F Last updated on2026-03-14 22:30:55。

Sneaking through the brush is immersive until the screen just freezes for about 100ms every time I rotate the camera. It totally kills the vibe. My Vastarmor Radeon RX 9060 XT 16GB OC was using 9,2GB - 10,5GB of VRAM, but the driver was clearly choking on the new engine's instruction set. I tried dropping texture quality to Medium, but the stutters didn't budge and the game looked like mud, which told me this was a low-level driver issue. I booted into Safe Mode, used DDU to nuke every trace of the old drivers, and did a clean install of the 26,1,2 stable build. Looking at Last updated on2026-03-23 18:22:00。

Every time a massive Eikon attack hits the screen, my PC just gives up and throws a BSOD. It was incredibly stressful. Checking the event logs showed kernel power errors, and I noticed the Vcore on my ASUS TUF B760M-PLUS D4 was dipping by 0,12V during peak loads. I tried switching to the Windows High Performance power plan, but that actually made the crashes more frequent, which was just frustrating. I eventually went into the BIOS -> Advanced -> Voltage settings, changed the Load-Line Calibration from Auto to Level 4, and bumped the CPU core voltage to 1,32V. Running OCCT Last updated on2026-03-24 19:55:02。