The loading bar would just hang at 90%, making my high-end NVMe feel like a dinosaur from the HDD era, though the raw potential of the drive kept me intrigued. The Zhitai TiPro9000 was choking on fragmented map assets because the file system alignment was off, causing the bandwidth to swing wildly between 40MB/s and 60MB/s. I tried the 'High Performance' power plan in Windows, but that only shaved off one second—totally useless. I ended up using a partition tool to re-align the 4K sectors and updated the NVMe driver to the latest version. AIDA64 random read tests then stabilized at 75-82MB/s, and map loads dropped to a swift 4 seconds. I did have a scare where some old saves became unreadable, but a quick backup restore fixed it. Drive temps are sitting at 42°C - 50°C. Throughput is finally optimized, and frame times are locked at 5.1-6.4ms. Last updated onMarch 16, 2026 4:45 PM.
Whenever more than twenty large creatures appeared, my FPS would dive from 60 to 30, which completely ruined the immersion. I saw my memory bandwidth utilization hovering between 88-95%, causing a massive I/O bottleneck. I tried 'High Performance' mode in the drivers, and while the system felt more responsive, the stutters remained. I got determined to crush the timings manually. In the BIOS, I tightened the primary timings from 16-16-16-39 down to 14-14-14-34 and bumped the voltage to 1.35V. This gave me a 12% boost in bandwidth and made scene loading feel way more fluid. I actually broke the boot sequence once by pushing it too far, but loosening tRCD by 2 units brought it back to life. Temps are stable at 45-52℃. Comparing the frame time graphs, the spikes are basically gone. Last updated onMarch 18, 2026 4:10 PM.
Going from a silky 300 FPS down to 140 FPS is a nightmare, but it gave me the perfect excuse to stress test the Ultra 9's new scheduling logic. The E-cores were introducing a 15-25ms sync delay when handling esports logic, causing the frame generation time to jump all over the place. I started with the 'Ultimate Performance' power plan in Windows, but while the P-cores boosted, the E-cores kept stealing cycles—a frustrating realization that I needed to perform surgery in the BIOS. I disabled all E-cores and locked the P-cores at a steady 5.4GHz. Looking at the RivaTuner graph, the frame time immediately collapsed into a tight 3.2-3.6ms window, and the stutters vanished. My idle power draw jumped by about 20W after disabling E-cores, but I managed to bring it back down by tweaking the C-State power management. CPU temps hovered between 65-78℃. I switched the operating mode in the driver panel, and frame times have stayed rock steady at 3.2-3.6ms. Last updated onMarch 21, 2026 1:55 PM.
Going from a silky 300 FPS down to 140 FPS is a nightmare, but it gave me the perfect excuse to stress test the Ultra 9's new scheduling logic. The E-cores were introducing a 15-25ms sync delay when handling esports logic, causing the frame generation time to jump all over the place. I started with the 'Ultimate Performance' power plan in Windows, but while the P-cores boosted, the E-cores kept stealing cycles—a frustrating realization that I needed to perform surgery in the BIOS. I disabled all E-cores and locked the P-cores at a steady 5.4GHz. Looking at the RivaTuner graph, the frame time immediately collapsed into a tight 3.2-3.6ms window, and the stutters vanished. My idle power draw jumped by about 20W after disabling E-cores, but I managed to bring it back down by tweaking the C-State power management. CPU temps hovered between 65-78℃. I switched the operating mode in the driver panel, and frame times have stayed rock steady at 3.2-3.6ms. Last updated onMarch 21, 2026 1:55 PM.
Going from a silky 300 FPS down to 140 FPS is a nightmare, but it gave me the perfect excuse to stress test the Ultra 9's new scheduling logic. The E-cores were introducing a 15-25ms sync delay when handling esports logic, causing the frame generation time to jump all over the place. I started with the 'Ultimate Performance' power plan in Windows, but while the P-cores boosted, the E-cores kept stealing cycles—a frustrating realization that I needed to perform surgery in the BIOS. I disabled all E-cores and locked the P-cores at a steady 5.4GHz. Looking at the RivaTuner graph, the frame time immediately collapsed into a tight 3.2-3.6ms window, and the stutters vanished. My idle power draw jumped by about 20W after disabling E-cores, but I managed to bring it back down by tweaking the C-State power management. CPU temps hovered between 65-78℃. I switched the operating mode in the driver panel, and frame times have stayed rock steady at 3.2-3.6ms. Last updated onMarch 21, 2026 1:55 PM.
