Does Asgard DDR5 6000 C30 need timing calibration when base building causes frequency instability in Palworld?

Whenever I started expanding my base, the frame rate would start jumping around, making precise building a total pain. The ultra-low C30 timings on the Asgard DDR5 6000 were causing 12-18ms of instability, which led to sync errors between the CPU and the memory controller while handling hundreds of entities. I tried lowering the graphics settings, but the stutters stayed—it was a very frustrating loop. I eventually went back to the BIOS and loosened tRAS from 30 to 32, then locked the voltage at 1.35V using a software tool. In stress tests, the frequency stayed pegged at 6000MHz, and the hitching stopped. I did notice a slight system hang right after locking the voltage, so I had to drop the frequency by 50MHz to find the sweet spot. Temps are sitting at 50-56℃. Verified everything with HWInfo, and the thermal curve looks perfectly linear now.