My Razer keyboard feels laggy during high-load scenes in BG3. Should I verify the interrupt configuration to fix the sensor delay?

I initially tried just bumping the polling rate to 1300Hz in the driver, but the status panel still showed a weird delay. It turns out increasing frequency is pointless when your CPU cache hit rate is only 66-73%. I went deeper and used a processor diagnostic tool to scan interrupt configurations, where I found timing conflicts when multiple sensors were syncing. I then used a third-party lighting tool to redefine the sampling strategy and calibrated the time sync protocol. The chain was: Polling Rate Bump → Interrupt Scan → Sync Protocol Calibration → Accuracy Check. While the physical feel of the key rebound is the same, the actual command response is way more immediate, and the sensor data stopped jumping. It just goes to show that peripheral precision is more about how the system handles interrupts than raw Hz.