Fixing frequency instability on Gloway DDR5 6000MHz?
The scheduling logic on this RAM is just pathetic. Every time I loaded a map, the frequency would bounce wildly between 6000MHz and 4800MHz, leaving the progress bar stuck at 99% forever. The voltage on the Gloway Celestial Yi DDR5 6000MHz 16GB was swinging by 0.1V during low-load transitions, causing the memory controller to reset constantly and dragging load times from 10 seconds to 35 seconds. I tried updating the motherboard drivers first, but that just slowed down my boot time by a second and did nothing for the loading—I was honestly about to lose it. I went into the BIOS, switched the RAM voltage from Auto to a locked 1.35V, and disabled all power-saving modes. CPU-Z now shows the frequency dead-locked at 6000MHz with zero jumping, and the loading speed is back to normal. My first attempt at locking the voltage sent temps spiking to 62℃, so I had to slap on some small heatsinks to bring it down to 52-56℃. Latency is now steady at 75-80ns with 52GB/s bandwidth. Saved the profile to a BIOS backup, and it's been rock solid since.
