Should I change TRIM settings for Zhitai TiPro9000 2TB in No Rest?
It is unbearable. I have a 2TB drive, but once it hits 80% capacity, the loading speeds feel like I'm back on a mechanical hard drive from 2010. The Zhitai TiPro9000's NAND crashes from 7000MB/s down to a pathetic 300-500MB/s once the cache is exhausted, causing the game to freeze for up to 3 seconds during scene swaps. I tried using third-party software to force TRIM commands, but the speeds stayed in the gutter—that whole process was just exhausting. I eventually cleared 400GB of junk and disabled the disk write cache in advanced settings to stop the latency buildup. AIDA64 showed read latency dropping from 90-120ns to a much better 65-80ns. Disabling the cache made small file copies painfully slow at first, so I re-enabled it but kept a strict over-provisioning strategy. Temps are 40-52℃, and the input response is finally crisp and immediate.
