Fixing interface sync for Great Wall GW3300 in Zenless Zone Zero?
The visual impact of entering a new area is amazing, but the technical side was a mess. The Great Wall GW3300 struggles with high-frequency resource swaps, and the PCIe bus bandwidth was swinging wildly between 10-12GB/s, causing a sync offset of 15-25ms. I first tried V-Sync to kill the tearing, but it pushed my input lag over 60ms, making the combat feel like I was wading through mud. I eventually went into the BIOS and forced the PCIe mode to Gen3 High Performance and locked my virtual memory to a fixed 16GB range. In RivaTuner, the frame time collapsed from 25-42ms down to a tight 16-22ms, and the tearing vanished. I had some boot delays after locking the page file, but reassigning it to a specific SSD partition sorted it out. Motherboard temps are around 50-56℃, and the transition between scenes is finally buttery smooth.
