How to stabilize Kingbank Yin Jue 3600MHz for Alan Wake 2?
Just as the eerie atmosphere was peaking, my frames would tank to 20 FPS, turning the excitement into pure frustration. Looking at the logs, the Kingbank sticks were running at 3600 MHz, but the memory controller was hitting 10-15 ms sync delays during heavy texture loads. I tried DLSS Performance mode first, but the image became a blurry mess, which is just not acceptable for a game this pretty. I went back into the BIOS, re-loaded the XMP profile, and bumped the DRAM voltage from 1.35V to 1.38V, while also pushing the SoC voltage to 1.15V. In CPU-Z, the memory latency tightened from 82 ns down to 74 ns, and the stutters basically vanished. I did notice some annoying coil whine while idling after the voltage bump, but switching the motherboard power mode to 'Balanced' killed the noise. RAM is steady at 46-52℃ and the VRMs are at 60-66℃. The in-game overlay confirms the memory mode is now stable.
