How to verify DeepCool sensor accuracy in Helldivers 2?
I documented my failures on this one to save you the trouble. At first, I tried scanning the interrupt config in a generic tool, but the cache hit rate just bounced between 67% - 74% and the data was still lagging. Total fail. I realized the issue was a timing conflict between multiple sensors. I changed the toolchain: used the hardware control software to modify the sampling strategy, calibrated the time sync protocol, and then quantified the sensor accuracy. When the sampling frequency fluctuated between 880Hz - 1280Hz, the data refresh lag dropped from 200ms to under 40ms. Now, the hardware panel values sync perfectly with the actual load, and that annoying data delay is gone. The final check confirms the state verification is running. It turns out the precision issue wasn't the sensor itself, but how the system handles interrupts and sync protocols.
